Skip to content

How Did Apollo 17 Astronauts Fix the Lunar Rover's Broken Fender?

November 13, 2026

During Apollo 17 in December 1972, Gene Cernan accidentally tore off the lunar rover’s rear fender extension with his hammer; after duct tape failed, engineers in Houston devised a fix using four laminated maps taped together and two utility clamps — an improvised repair that held for the final two moonwalks in history.

The Accident That Almost Derailed the Last Moonwalks

On December 11, 1972, during the first of three planned moonwalks, Commander Gene Cernan brushed against the lunar rover and his hammer snagged the rear fender extension, tearing it clean off. It was a small piece of equipment with an enormous job: without it, the rover’s wheels flung continuous arcs of lunar dust — called rooster tails — across the vehicle, the instruments, and the spacesuits of Cernan and geologist Harrison Schmitt.

Lunar dust is nothing like the fine sand you’d find on a beach. Billions of years of micrometeorite bombardment have ground the Moon’s surface into particles with razor-sharp, jagged edges. There is no wind or water on the Moon to wear them smooth. That grit is abrasive, clingy, and relentless — and in large quantities, it posed a serious threat to the mission.

Why Lunar Dust Was Such a Dangerous Problem

The immediate concern was thermal, not just mechanical. Dark lunar dust absorbs sunlight efficiently, and when it coated the rover’s battery radiators, those radiators could no longer shed heat into space. This was not a theoretical risk: on Apollo 16, the preceding mission, the rover’s batteries had already pushed past their safe operating limits. A repeat on Apollo 17 — with far more ambitious drives planned across the Taurus-Littrow valley — could have cut the final moonwalks short or ended them entirely.

The crew tried the obvious fix first: duct tape. It held the broken fender extension in place for a few hours, but lunar dust defeated the adhesive on the drive back to the lander. Even duct tape — the universal symbol of improvised repair — has limits, and at 240,000 miles from Earth, they had reached them.

The Map-and-Clamp Solution

While Cernan and Schmitt slept between moonwalks, engineers at Mission Control in Houston worked through the problem. Their solution was elegant in its simplicity. Four laminated — plastic-coated — maps, the kind carried aboard the lunar module as navigational references, were taped together in a cross pattern to form a stiff, curved panel roughly the size and shape of the missing fender extension. Two clamps normally used to mount utility lights inside the lunar module cabin were then slid onto the rover’s existing fender guide rails, locking the map panel securely in place.

The instructions were radioed up to the crew, the assembly took only minutes, and it worked.

The Fix That Closed Out the Apollo Era

The improvised fender held for the remaining two moonwalks — the longest drives ever made on the lunar surface. Cernan and Schmitt explored the valley floor and the surrounding highlands without further incident, collecting samples and deploying scientific instruments. When Gene Cernan stepped off the lunar surface on December 14, 1972, he became — and remains — the last human to stand on the Moon.

The map fender that made those final drives possible was brought back to Earth and is now preserved at the National Air and Space Museum in Washington, D.C. Four laminated maps and two clamps: the most consequential improvised car repair in history, assembled in a lunar module cabin by flashlight, a quarter of a million miles from home.

FREQUENTLY ASKED

What happened to the Apollo 17 lunar rover's fender? ▾

Gene Cernan accidentally knocked off the rear fender extension with his hammer during the first moonwalk on December 11, 1972, causing the rover's wheels to throw up dangerous rooster tails of abrasive lunar dust.

Why was losing the rover fender so dangerous on Apollo 17? ▾

Lunar dust is extremely sharp and abrasive, and when it coated the rover's battery radiators, the batteries could overheat — a problem that had already pushed Apollo 16's rover past its safe limits.

How did NASA fix the Apollo 17 rover fender? ▾

Engineers in Houston designed a replacement using four laminated maps taped into a stiff panel, secured to the rover's existing guide rails with two utility light clamps from inside the lunar module.

Did duct tape work on the Moon? ▾

Only briefly — the crew taped the broken fender extension back on, but lunar dust defeated the adhesive within a few hours, and the extension fell off again on the drive back to the lander.

Where is the Apollo 17 map fender now? ▾

The improvised fender made from four laminated maps and two clamps was returned to Earth after the mission and is now on display at the National Air and Space Museum in Washington, D.C.

Who were the last humans to walk on the Moon? ▾

Gene Cernan and Harrison Schmitt of Apollo 17 made the last lunar surface excursions in December 1972; Cernan was the final person to step off the Moon on December 14, 1972.

GO DEEPER

KEEP EXPLORING